Parameters

Name	Description
MessageId	protocol command ID
Guid	UniqID
NetworkType	Access network: 0 – unknown 1 — Ethernet 2 — WIFI 3 – 2G 4 – 3G 5 – 4G 6 – 5G 7 – WIFI+3/4/5G, connect with mobile network proxy via WIFI to access Internet 8 – CABLE+3/4/5G, connect with mobile network proxy via CABLE to access Internet
Phone	Mobile phone number
DeviceType	Channel number. For exmaple 0x4000 – means the 4 channels MDVR
DeviceModel	Model of device
LocationMode	location info (0: no, 1: exist)
VehicleKey	ACC (0-invalid, 1-valid)
Brake	break (0-invalid, 1=valid)
TurnLeft	turn left (0-invalid, 1-valid)
TurnRight	turn right (0-invaid, 1-valid)
MoveOn	forward (0-invalid, 1-valid)
Reverse	backword (0-invalid, 1-valid)
LeftFrontDoor	left front door (0-Close, 1-Open)
RightFrontDoor	right front door (0-close, 1-Open)
LeftMiddleDoor	left mid door (0-close, 1-Open)
RightMiddleDoor	right mid door (0-close, 1-open)
LeftBackDoor	left back door (0-close, 1-open)
RightBackDoor	right back door (0-close, 1-open)
MobileNetworkModule	Mobile network status: 0—unknown, 1—normal, 2—abnormal,3—not exist
LocationModule	GPS module status status: 0—unknown, 1—normal, 2—abnormal,3—not exist
WIFIModule	WiFi module status status: 0—unknown, 1—normal, 2—abnormal,3—not exist
GSensorModule	GSensor module status status: 0—unknown, 1—normal, 2—abnormal,3—not exist
MobileNetworkSignal	0: invalid, 1~10 (strongest)
MobileNetworkType	Type of mobile network
WIFISignal	0: invalid, 1~10 (strongest)
WIFINetworkAddress	192.168.0.1, byte [0] =0xC0, byte [1] =0xA8, byte [2] =x000, byte [3] =0x01
WIFIGateway	192.168.0.1, byte [0] =0xC0, byte [1] =0xA8, byte [2] =x000, byte [3] =0x01
WIFINetworkMask	192.168.0.1, byte [0] =0xC0, byte [1] =0xA8, byte [2] =x000, byte [3] =0x01
DiskStatus	Disk status 0 – Unknown 1 – In recording 2 – Standby 3 – Abnormal 4 – Disk full
DiskCapacityMB	Capacity(MB)
DiskFreeSpaceMB	Free space(MB)
SensorInputAlarm1	0:Invalid,1:Valid
SensorInputAlarm2	0:Invalid,1:Valid
EmergencyAlarm	0-Not triggered，1-Triggered
Temperature	Temperature inside vehicle
OutdoorTemperature	Outdoor temperature
EngineTemperature	Temperature of engine
DeviceTemperature	Temperature of device
HumidityInVehicle	Humidity inside vehicle
HumidityOutsideVehicle
Mileage	GPS ODO value
DayMileage	ODO value for current day
AlarmStartTime	Time when trigger started
AlarmEndime	Time when trigger stoped
AlarmType	<1000: alarm notification >1000: event notification See Table #1
ADAS	ADAS/DMS code. See table #2
StorageStatus	0 – Missing 1 – Broken (disk partition fatal error) 2 – The log cannot be overwritten 3 – Failed to write Block (EIO write error) 4 – Disk failure (disk cannot be partitioned) 5 – The disk cannot be mounted: the log partition cannot be mounted 6 – There are too many bad blocks in disk video storage, more than 20% 7 – Disk invalid block: Judge the video partition, at the beginning of formatting, or when the key information of the corresponding file is updated later 8 – Disk video sampling verification failed: Failed when compare key information, after a file is finished 9 – Disk pauses to write video: 3 consecutive pauses will be reported once 10 – Disk recording overwrite exception: a kind of verification for false writing 11 – The disk has not recorded for a long time: no recording has been written for more than 2 minutes 12 – The disk is written slowly, causing the cached data to be overwritten

Table #1

Value	Description
Value	Description
0	unknown
1	video lost
2	motion detection
3	video blind
4	input trigger
5	emergency alarm
6	low speed alarm
7	over speed alarm
8	low temperature alarm
9	high temperature alarm
10	humidity alarm
11	parking over time
12	acceleration alarm
13	GEO fencing
14	electronic route
15	abnormal open/close the door
16	storage abnormal
17	fatigue driving
18	fuel consumption abnormal
19	ACC off. (compatible with old firmwares. In old firmwares:During ACC-off delay, if ignites (et > st), will report “accoff ends”; in new firmware: During ACC-off delay, if ignites (et > st), will report “accon”)
20	GPS module abnormal
21	front panel open
22	Swipe card
23	IBUTTON
24	Harsh acceleration
25	Harsh braking
26	Low speed warning
27	High speed warning
28	Voltage alarm
29	People counting
30	DMS and ADAS alarm (Driver monitoring system, and Advanced Driving Assistant System)
31	“Acc on”. Report once at boot
32	Idle
33	Gps antenna break
34	Gps antenna short
35	IO output
36	CAN Bus connection abnormal
37	Towing
38	Free wheeling
39	RPM exceeds
40	Vehicle Move
41	Trip start（st/et/dtu time same）
42	In trip
43	Trip ends (periodically report after acc off)
44	GPS location recover
45	Video abnormal
46	None trip position (report periodically after trip ends)
47	Main unit anomly (Device not connected for long time, periodical alarms)
48	Excessive overspeed
49	Load alarm
768	Trip notification
769	Tire pressure notification
770	Disk detection alarm
1280	Alarm file
1281	Timer Snapshot
1282	Alarm file (in visible partition)
1283	ftp file upload notification

Table #2

Value	Description
Value	Description
17	FCW Forward collision warning #1
18	HMW Front vehicle distance is too close #1
2	LDW Lane departure warning #1
4	PCW Pedestrian collision warning #1
7	Front Vehicle Start #1
3	HMW Front vehicle distance is too close #2
6	Road sigh violation alarm #2
1	FCW Forward collision warning #3
8	Harsh breaking #3
19	LDW_L Left lane departure #3
20	LDW_R Right lane departure #3
21	VB Low-speed forward collision alarm #3
5	Frequent lane change alarm
16	Road sign recognition incident
33	Fatigue driving alarm #1
34	Calling alarm #1
35	Smoking alarm #1
49	Driver change duty #1
65	Eyes closing #1
66	Yawning #1
67	Camera cover alarm #1
68	glance right and left #1
69	Not wearing a seat belt #1
70	Driver leave duty #1
71	Drinking water
73	Driver returns #1
80	Infrared sunglasses #1
81	Driver authentication succeeded #1
82	Driver authentication failed #1
36	Distracted driving alarm #2
37	Driver abnormal alarm #2
72	Driver changed #3
83	No face detected #3
85	Mask not worn
96	BSD left level 1
97	BSD left level 2
98	BSD left level 3
99	BSD right level 1
100	BSD right level 2
101	BSD right level 3