| Name | Description |
|---|---|
| MessageId | protocol command ID |
| Guid | UniqID |
| NetworkType | Access network: 0 – unknown 1 — Ethernet 2 — WIFI 3 – 2G 4 – 3G 5 – 4G 6 – 5G 7 – WIFI+3/4/5G, connect with mobile network proxy via WIFI to access Internet 8 – CABLE+3/4/5G, connect with mobile network proxy via CABLE to access Internet |
| Phone | Mobile phone number |
| DeviceType | Channel number. For exmaple 0x4000 – means the 4 channels MDVR |
| DeviceModel | Model of device |
| LocationMode | location info (0: no, 1: exist) |
| VehicleKey | ACC (0-invalid, 1-valid) |
| Brake | break (0-invalid, 1=valid) |
| TurnLeft | turn left (0-invalid, 1-valid) |
| TurnRight | turn right (0-invaid, 1-valid) |
| MoveOn | forward (0-invalid, 1-valid) |
| Reverse | backword (0-invalid, 1-valid) |
| LeftFrontDoor | left front door (0-Close, 1-Open) |
| RightFrontDoor | right front door (0-close, 1-Open) |
| LeftMiddleDoor | left mid door (0-close, 1-Open) |
| RightMiddleDoor | right mid door (0-close, 1-open) |
| LeftBackDoor | left back door (0-close, 1-open) |
| RightBackDoor | right back door (0-close, 1-open) |
| MobileNetworkModule | Mobile network status: 0—unknown, 1—normal, 2—abnormal,3—not exist |
| LocationModule | GPS module status status: 0—unknown, 1—normal, 2—abnormal,3—not exist |
| WIFIModule | WiFi module status status: 0—unknown, 1—normal, 2—abnormal,3—not exist |
| GSensorModule | GSensor module status status: 0—unknown, 1—normal, 2—abnormal,3—not exist |
| MobileNetworkSignal | 0: invalid, 1~10 (strongest) |
| MobileNetworkType | Type of mobile network |
| WIFISignal | 0: invalid, 1~10 (strongest) |
| WIFINetworkAddress | 192.168.0.1, byte [0] =0xC0, byte [1] =0xA8, byte [2] =x000, byte [3] =0x01 |
| WIFIGateway | 192.168.0.1, byte [0] =0xC0, byte [1] =0xA8, byte [2] =x000, byte [3] =0x01 |
| WIFINetworkMask | 192.168.0.1, byte [0] =0xC0, byte [1] =0xA8, byte [2] =x000, byte [3] =0x01 |
| DiskStatus | Disk status 0 – Unknown 1 – In recording 2 – Standby 3 – Abnormal 4 – Disk full |
| DiskCapacityMB | Capacity(MB) |
| DiskFreeSpaceMB | Free space(MB) |
| SensorInputAlarm1 | 0:Invalid,1:Valid |
| SensorInputAlarm2 | 0:Invalid,1:Valid |
| EmergencyAlarm | 0-Not triggered，1-Triggered |
| Temperature | Temperature inside vehicle |
| OutdoorTemperature | Outdoor temperature |
| EngineTemperature | Temperature of engine |
| DeviceTemperature | Temperature of device |
| HumidityInVehicle | Humidity inside vehicle |
| HumidityOutsideVehicle | |
| Mileage | GPS ODO value |
| DayMileage | ODO value for current day |
| AlarmStartTime | Time when trigger started |
| AlarmEndime | Time when trigger stoped |
| AlarmType | <1000: alarm notification >1000: event notification See Table #1 |
| ADAS | ADAS/DMS code. See table #2 |
| StorageStatus | 0 – Missing 1 – Broken (disk partition fatal error) 2 – The log cannot be overwritten 3 – Failed to write Block (EIO write error) 4 – Disk failure (disk cannot be partitioned) 5 – The disk cannot be mounted: the log partition cannot be mounted 6 – There are too many bad blocks in disk video storage, more than 20% 7 – Disk invalid block: Judge the video partition, at the beginning of formatting, or when the key information of the corresponding file is updated later 8 – Disk video sampling verification failed: Failed when compare key information, after a file is finished 9 – Disk pauses to write video: 3 consecutive pauses will be reported once 10 – Disk recording overwrite exception: a kind of verification for false writing 11 – The disk has not recorded for a long time: no recording has been written for more than 2 minutes 12 – The disk is written slowly, causing the cached data to be overwritten |
Table #1
| Value | Description |
|---|---|
| Value | Description |
| 0 | unknown |
| 1 | video lost |
| 2 | motion detection |
| 3 | video blind |
| 4 | input trigger |
| 5 | emergency alarm |
| 6 | low speed alarm |
| 7 | over speed alarm |
| 8 | low temperature alarm |
| 9 | high temperature alarm |
| 10 | humidity alarm |
| 11 | parking over time |
| 12 | acceleration alarm |
| 13 | GEO fencing |
| 14 | electronic route |
| 15 | abnormal open/close the door |
| 16 | storage abnormal |
| 17 | fatigue driving |
| 18 | fuel consumption abnormal |
| 19 | ACC off. (compatible with old firmwares. In old firmwares:During ACC-off delay, if ignites (et > st), will report “accoff ends”; in new firmware: During ACC-off delay, if ignites (et > st), will report “accon”) |
| 20 | GPS module abnormal |
| 21 | front panel open |
| 22 | Swipe card |
| 23 | IBUTTON |
| 24 | Harsh acceleration |
| 25 | Harsh braking |
| 26 | Low speed warning |
| 27 | High speed warning |
| 28 | Voltage alarm |
| 29 | People counting |
| 30 | DMS and ADAS alarm (Driver monitoring system, and Advanced Driving Assistant System) |
| 31 | “Acc on”. Report once at boot |
| 32 | Idle |
| 33 | Gps antenna break |
| 34 | Gps antenna short |
| 35 | IO output |
| 36 | CAN Bus connection abnormal |
| 37 | Towing |
| 38 | Free wheeling |
| 39 | RPM exceeds |
| 40 | Vehicle Move |
| 41 | Trip start（st/et/dtu time same） |
| 42 | In trip |
| 43 | Trip ends (periodically report after acc off) |
| 44 | GPS location recover |
| 45 | Video abnormal |
| 46 | None trip position (report periodically after trip ends) |
| 47 | Main unit anomly (Device not connected for long time, periodical alarms) |
| 48 | Excessive overspeed |
| 49 | Load alarm |
| 768 | Trip notification |
| 769 | Tire pressure notification |
| 770 | Disk detection alarm |
| 1280 | Alarm file |
| 1281 | Timer Snapshot |
| 1282 | Alarm file (in visible partition) |
| 1283 | ftp file upload notification |
Table #2
| Value | Description |
|---|---|
| Value | Description |
| 17 | FCW Forward collision warning #1 |
| 18 | HMW Front vehicle distance is too close #1 |
| 2 | LDW Lane departure warning #1 |
| 4 | PCW Pedestrian collision warning #1 |
| 7 | Front Vehicle Start #1 |
| 3 | HMW Front vehicle distance is too close #2 |
| 6 | Road sigh violation alarm #2 |
| 1 | FCW Forward collision warning #3 |
| 8 | Harsh breaking #3 |
| 19 | LDW_L Left lane departure #3 |
| 20 | LDW_R Right lane departure #3 |
| 21 | VB Low-speed forward collision alarm #3 |
| 5 | Frequent lane change alarm |
| 16 | Road sign recognition incident |
| 33 | Fatigue driving alarm #1 |
| 34 | Calling alarm #1 |
| 35 | Smoking alarm #1 |
| 49 | Driver change duty #1 |
| 65 | Eyes closing #1 |
| 66 | Yawning #1 |
| 67 | Camera cover alarm #1 |
| 68 | glance right and left #1 |
| 69 | Not wearing a seat belt #1 |
| 70 | Driver leave duty #1 |
| 71 | Drinking water |
| 73 | Driver returns #1 |
| 80 | Infrared sunglasses #1 |
| 81 | Driver authentication succeeded #1 |
| 82 | Driver authentication failed #1 |
| 36 | Distracted driving alarm #2 |
| 37 | Driver abnormal alarm #2 |
| 72 | Driver changed #3 |
| 83 | No face detected #3 |
| 85 | Mask not worn |
| 96 | BSD left level 1 |
| 97 | BSD left level 2 |
| 98 | BSD left level 3 |
| 99 | BSD right level 1 |
| 100 | BSD right level 2 |
| 101 | BSD right level 3 |
Contact us
CONTACTS
Our Email
Our Address
Flat 2005, Sliver Tower, Al khaleej Road, Business Bay Metro Station, Dubai, United Arab Emirates, 27795
Stay Updated with the Latest News from Our Company: Subscribe to receive the newest updates and insights directly from our team. Be the first to know about our latest developments, innovations, and offerings
Contact us
Our Email
CONTACTS
Our Adress
Flat 2005, Sliver Tower, Al khaleej Road, Business Bay Metro Station, Dubai, United Arab Emirates, 27795
Stay Updated with the Latest News from Our Company: Subscribe to receive the newest updates and insights directly from our team. Be the first to know about our latest developments, innovations, and offerings